Alternating Current (AC)
The direction of an electric charge that is flowing in a circuit is constantly being reversed back and forth.
The standard unit of measure for electrical current, defined as the amount of electrical flow equal to one coulomb per second.
The product of the applied voltage and current in an AC circuit.
A power failure in which line voltage drops to zero.
A drop in voltage in electrical power supply.
Full automatic voltage regulation in a UPS stabilizes low voltage (boost) and high voltage (buck) to maintain nominal 230V power, without resorting to battery power when minor power fluctuations occur.
Cables that are made of an inner conductor surrounded by an insulator and a shield that are generally used for TV antennas, satellite dishes, cable modems and certain computer networking applications.
The flow of electric charge, measured in amps.
Dynamic Host Configuration Protocol (DHCP), automatically assigns an IP address to a device on a network.
Direct Current (DC)
The unidirectional flow of a electric charge.
This high-end UPS system converts incoming utility AC power into DC power and then back into AC power, charging connected devices with the UPS battery. The isolated process ensures clean and stable output voltage and zero transfer time. This UPS system is ideal for equipment sensitive to power fluctuations such as corporate data centers, servers, and network and storage devices.
Efficiency (Energy Conversion Efficiency)
The ratio between the amount of apparent power and the amount of true power used by an electrical device. The closer the true power value is to the apparent power, the more efficient the device.
Electromagnetic Interference (EMI)
Commonly referred to as line noise, these interference signals can disrupt or degrade the performance of a circuit by inserting abnormalities into the system. Also referred to as radio frequency interference (RFI) when in high or radio frequency.
The number of cycles in a given time period, which is measured in Hertz.
An electrical system connection that serves as a conduit between the circuit and earth.
The midpoint in the maximum load capacity for a UPS.
High amperage devices that require installation by a qualified electrician to be directly wired-in, instead of simply being plugged in to an outlet.
The unit for frequency, defined as the number of cycles per second.
A term used to describe the functions of replacing a UPS battery without shutting down the unit.
A measure of electrical energy — one joule is defined as the energy needed to pass one ampere of current through one ohm of resistance.
Functions the same as a standby UPS, with the additional feature of some voltage regulation built in. It switches to battery power when voltage drops too low, just as a standby UPS does, however if the voltage only drops slightly, a line-interactive UPS corrects this without using battery power. The functionality of these mid- to high-grade units falls between standby and online UPS units.
The amount of power consumed by an electrical device on a circuit. Load capacity is a critical factor in selecting a UPS or surge protector.
Metal Oxide Varistor is an electronic component that is used to protect circuits against excessive, short-lived, voltages.
The standard voltage for a circuit or system. Common nominal voltages in the U.S. include 120VAC, 208VAC and 240VAC; while nominal voltage in the EU is 230VAC.
This occurs when incoming voltage is higher than normal but not high enough to be classified as a surge.
Power Factor (PF)
The ratio of real power (watts) to apparent power (VA), expressed as a number between 0 and 1. Watts divided by VA = Power Factor
Power Factor Correction
Controls the incoming power to a power supply in order to bring the power factor as close to unity power as possible.
Radio Frequency Interference (RFI)
See Electromagnetic Interference.
The amount of power being drawn by a system, measured in watts. Real power is a function of VA (apparent power) and the power factor.
RJ11, RJ14, RJ45
The abbreviation of registered jack (RJ) – RJ11 is for standard phone lines, RJ14 is for multiple phone lines and RJ45 is for Ethernet.
The maximum period of time battery power is output from a UPS to its connected devices during a power interruption. Runtime is dependent upon the total load of all connected equipment.
Simulated Sine Wave
A modified or approximated sine wave AC power output. Simulated (or nonsinusoidal) waveforms may also be referred to as a squared sine wave, modified sine wave, trapezoidal sine wave or quasi sine wave.
A smooth, repetitive oscillation of AC power.
Single Phase Power
Refers to the distribution of alternating current electric power using a system in which all the voltages of the supply vary in unison.
Simple Mail Transfer Protocol is the standard for e-mail transmission on the Internet
Simple Network Management Protocol is a commonly used protocol for devices to communicate over a network.
A spike is a sudden, brief power surge, usually lasting less than 1ms.
A UPS that passes utility power straight through to the output when conditions are stable, but switches to battery power when utility voltage drops below an acceptable level.
Periods when line voltage increases dramatically, typically lasting longer than 1ms, but less than a few seconds, though they can last longer.
Total Harmonic Distortion (THD)
A calculated measure of the reduction in sine wave clarity caused by stray wave frequencies.
The process of dissipating heat from an electrical system via air or liquid cooling; also a term for the amount of heat a device can emit.
The time it takes UPS to switch from AC power to battery power.
A device that converts AC line voltage to a higher or lower value.
The standard unit of measure for rack-mounted equipment. A device measuring 1U is 1.75 inches high, 2U is 3.50 inches, etc.
Related to both brownout and voltage sag, undervoltage falls between these two, occurring when voltage is lower than normal for an extended period of time without recovering, but not to low that the electronic device will not function.
USB (HID Compliant)
Universal Serial Bus devices are used to connect various components to a computer. An HID (Human Interface Device) compliant USB follows a specific protocol for communication that allows it to be used with virtually any system.
The difference in electric potential between two points when one amp of current dissipates one watt of power.
The unit used to express apparent power.
A device or component that normalizes voltage to a certain standard when it is fluctuating.
A unit of measure for true power consumption.
Is a representation (or form) of how alternating current (AC) varies with time. Common waveform representations include sine wave, square wave and trapezoidal wave. An instrument called an oscilloscope can be used to visually represent a wave as a repeating image on a screen.
Refers to an abnormal flow of current that is due to an improperly grounded electrical outlet.
- More than 100 distributors and retail locations worldwide
- Won Data Center 100 and Top 20 Infrastructure Provider by CRN three times in a row since 2013
- Received the world's first Energy Star certificate from CSA group and was awarded Energy-efficient IT Systems by Green IT Best Practice Award 2012
- Launched Datacenter UPS systems product line, and developed software compatibility with critical virtualization technology partners, including VMware, Hyper-V, Red Hat, and Citrix
- Established office in Japan and started sales through channels in Australia to expand its business presences in Asia-Pacific region
- CyberPower started Initial Public Offering (IPO) in Taiwan stock market
- Launched the first high-frequency energy-saving UPS with ultra-efficient technology
- Recognized as ''Best New Vendor of the Year'' by Ingram Micro, the world's largest distributor of computer and technology products
- Developed and launched DC UPS for Telecom industry
- Commenced partnership with the world's largest IT distributor and global network technology provider, Tech Data and Tellabs
- Certified by UL LCC to provide advanced testing environment
- Performed safety tests, EMI certification and pre-testing to accelerate the development process and enhance engineering excellence
- Introduced UPS Power98, the first UPS designed to be compatible with Windows 98
- Entered the world's largest and multi-national retail stores: Walmart, BestBuy and Fry's
Your web browser is no longer supported.
Please upgrade to a modern, fully supported browser for best performance of the site.
By closing this window you acknowledge that your experience on our website may be degraded.
Find the serial number on your CyberPower products
Every CyberPower product has a unique serial number (S/N) and they can only be 12 or 16 digits.
The location of the serial number label may vary by different products, but you can find it on the back or bottom side of most products.
Are you sure you want to leave this page? The selected itmes will be cleared.Restart Stay on this page
Thanks for registering with us. An email has been sent to you with a link to activate your account. If you do not receive the email, please check your spam folder or contact us.OK
Your account has been activated successfully
The link has either expired or is no longer valid.
There is no record for the product registration now.
This serial number is not for a qualifying product. Please check if the serial number is the same as that on your package box.OK
Your password reset request has been submitted. An email with instructions will be sent to your inbox. If not received, please check your email spam or junk folder.OK
This product is not available in this region, please check with your local dealer for details.
Warning！You are now leaving our website.
Please log in to register your product.
Please select a Product line.
Sorry, there are no results found based on your current selection of filters. Please adjust the value and try again. Power load should be number only. Please note the number can't be zero or minus.
Please fill in information below
- Power Load
This product is not available in your region.